ALL libraries (COBIB.SI union bibliographic/catalogue database)
13.
Standards for testing freeform measurement capability of optical and tactile coordinate measuring machines
Ačko, Bojan, 1961- ...
For decades three-dimensional (3D) measurements of engineering components have been made using fixed metrology-room based coordinate measuring machines (CMMs) fitted most commonly with single point ...or to a much lesser extent, scanning tactile probes. Over the past decade there has been a rapid uptake in development and subsequent use of portable optical-based 3D coordinate measuring systems. These optical-based systems capture vast quantities of point data in a very short time, often permitting freeform surfaces to be digitized. Documented standards, for example ISO 10360, for the verification of fixed CMMs fitted with tactile probes are now widely available, whereas verification procedures and more specifically verification artefacts for optical-based systems are still in their infancy. Furthermore, the industry is seeking traceability in 3D measurements of high precision components. A recent requirement is the demand for highly accurate measurements of large gears with diameters up to 1000 mm as used in gear boxes of wind turbines. Up until now it has been impossible to ensure traceability of 3D measurements of big gears, since no traceable standards were available. This paper describes three different types of artefacts that were developed during the project, namely tetrahedron artefacts for testing the basic measurement capability of optical 3D devices, freeform verification artefacts for testing the capability of measuring complex geometry, and a large gear artefact for task related calibration of different types of CMMs. In addition, artefact calibration data and associated measurement uncertainties and international inter comparisons are presented. These developments will be of considerable value to end users, calibration laboratories and producers of optical and tactile CMMs.
It was not necessary to add the material to the shelf.
Bibliographic material was successfully added on shelf.
Adding bibliographical material on shelf was not successful.
Material is already on the shelf.
Permalink
URL:
Impact factor
Access to the JCR database is permitted only to users from Slovenia. Your current IP address is not on the list of IP addresses with access permission, and authentication with the relevant AAI accout is required.
Year
Impact factor
Edition
Category
Classification
JCR
SNIP
JCR
SNIP
JCR
SNIP
JCR
SNIP
Impact factor
Select the library membership card:
DRS,
in which the journal is indexed
Database name
Field
Year
Links to authors' personal bibliographies
Links to information on researchers in the SICRIS system
Subject headings in COBISS General List of Subject Headings
Select pickup location
The material from the parent unit is free. If the material is delivered to the pickup location from another unit, the library may charge you for this service.
