VSE knjižnice (vzajemna bibliografsko-kataložna baza podatkov COBIB.SI)
  • Effect of surface topography on galling resistance of tool steel [Elektronski vir]
    Podgornik, Bojan, 1970- ; Jerina, Jure ; Vižintin, Jože
    Tribological evaluation of the tool steel, focused on determining coefficient of friction and critical load for galling initiation against austenitic stainless steel as a function of surface ... topography was carried out in a load-scanning test rig. Results show that by removing sharp peaks polishing of the bearing surface gives plateau-like topography and improves galling properties of forming tool steel. This becomes even more important when using hard ceramic coatings (i.e. TiN). When superbly polished contact surfaces can give similar galling resistance as otherwise obtained through contact lubrication. However, application of low friction coatings or introduction of micro-dimples with proper density and contact lubrication will result in superior galling resistance of the surface.
    Vir: Proceedings of the 3rd International IFHTSE Conference on "Heat Treatment and Surface Engineering of Tools and Dies", 23.-25. March 2011 Wels, Austria [Elektronski vir] (Str. 120-129)
    Vrsta gradiva - prispevek na konferenci
    Leto - 2011
    Jezik - angleški
    COBISS.SI-ID - 11793435

Vnos na polico